How to edit/delete "goodbye" message during standb

Stahlhagel · Post by **Stahlhagel** » January 3rd, 2006, 12:14 am

Is it possible to delete that message ? If i send my htpc into standby the "goodbye" message always is freezing on the display.
Is that an known issue ? What can i do against that behaviour ?
I use LCD Smartie 5.3 and that 2 x16 VFD of Silverstone LC10M.

That plugin really rocks !

Plz somone help me

Cu
Stahlhagel from Germany

Post by **limbo** » March 8th, 2006, 11:09 pm

Is this message caused by a plugin?
do you just want to not displayed or it freezes up your system with this?

ReverseEngineered · Post by **ReverseEngineered** » March 8th, 2006, 11:33 pm

I'm with Limbo on this one... where is this "goodbye" message coming from?

fano1 · Post by **fano1** » March 7th, 2007, 9:29 am

I'm suffering from this bug too...
It's possible to remove it?

Tanks,
fano1

Post by **limbo** » March 7th, 2007, 9:48 am

fano1 wrote:I'm suffering from this bug too...
It's possible to remove it?

Tanks,
fano1

The only exit message supported by application is located in Startup/shutdown tab.
Any other message (like "goodbye") must be caused from other source.
Maybe your display μC has build in a shutdown message.
In order to remove this you have to tweak your display (if vendor supports such command)

In addition you can try to set a message in LCD Smartie and check if it possile to override your "goodbye" display message.

fano1 · Post by **fano1** » March 8th, 2007, 9:13 am

I've installed the 5.4 version and left the shutdown message empty...
now it works

On the 5.3 version there wasn't that section.

fano1

MirkoEZlikovski · Post by **MirkoEZlikovski** » July 5th, 2010, 10:39 am

in my case only first row shows other three rows is frozen from current state, display is 4x20

How to edit/delete "goodbye" message during standb

How to edit/delete "goodbye" message during standb

Re: How to edit/delete "goodbye" message during standb