High CPU Usage with smartie

garya5150 · Post by **garya5150** » May 7th, 2006, 11:19 pm

Hi i'm haveing a problem with smartie when i open it my cpu load goes way up to 70% and stays high until i close smartie. anyone have this problem or know what may be causeing it? Thanks

jonny · Post by **jonny** » May 7th, 2006, 11:55 pm

i have that problem every once in a while, too. I am not sure what the cause is, but you should remove any dll calls that you not using from the config screen. (any disabled screens should not have any thing entered into the config lines)

garya5150 · Post by **garya5150** » May 8th, 2006, 10:45 pm

no one else has had this problem?

i've tried everything any idea's at all?

Post by **limbo** » May 9th, 2006, 6:22 am

which version are you using?
how many screen are enabled?
are you using any plugins on them?

garya5150 · Post by **garya5150** » May 9th, 2006, 9:58 pm

I tried the beta version thought it may be that but its doing it with 5.3 as well. I took out all plugins one by one to try and figure out which one but it still does it after all are out. thanks

Fast351 · Post by **Fast351** » May 10th, 2006, 11:46 am

Put the stock config.ini in there and see if the problem persists. If it's gone, then start putting your config back in 1 by 1 until it reappears.

garya5150 · Post by **garya5150** » May 15th, 2006, 2:03 am

I put in stock config and it didnt raise cpu use, so guess it's figure out what plugin is causing problem...thanks for eveyones help.