Control of GPO Pins on CFA-635

[hydrolisk1792]

Hello, I know that I have posted a lot of questions about this display lately, all the way down to how to get temperature readings from the SCAB board attachment, however I need to know if there is any way for Smartie to control GPO Pins 5 - 12 on the CFA-635 display. All I need is the pins to go high when something happeneds, and the pins to go low when something else happeneds. I tried the code in the actions tab already, but nothing happeneds. These are the pins that are connected to the LEDs on the front of the display, but I have the LEDs removed, so I can pick from the pins directly on the H2 header connector to control some transistors which trigger some relays. . . Is this possible in Smartie? If not can someone maybe make a plug in to make this possible? This is really needed for an up comming project, Thanks in advanced.