LCD Smartie

Plugin to interface with Libre Hardware Library. Similar to a plugin named sensor bridge but using Libre Hardware Monitor as Open Hardware Monitor hasn't been updated for a long time.

This has my special brew Libre Hardware Monitor library That supports PMBus sensors if that's any use to anyone

Github page https://github.com/stokie-ant/LHM
Releases https://github.com/stokie-ant/LHM/releases

Readme from Github page:

Includes binaries from Libre Hardware Monitor https://github.com/LibreHardwareMonitor ... areMonitor Libre Hardware Monitor is licenced under MPL 2.0

Notes
LCD Smartie has to be run as administrator to use this plugin. DNBridge.dll is required. Copy LHM.dll, LibreHardwareMonitorLib.dll and HidSharp.dll to LCD Smartie plugins dir. On first run it should create a report called LHMreport.txt in the plugins folder. It will have basic variables for accessing each sensor. Delete this file to have it re-created.

function 1 gets hardware or sensor name
function 2 gets subhardware name
function 3 gets sensor value
Syntax:
function 1
takes 1 parameter:
HardwareIndex

$dll(LHM.dll,1,0,0)
or

HardwareIndex#SensorIndex

$dll(LHM.dll,1,1#0,0)
or

HardwareIndex#SubHardwareIndex#SensorIndex

$dll(LHM.dll,1,0#0#0,0)
second parameter ignored but must be present (,0)

function 2
takes 1 parameter for cases where name is sub hardware not sensor
HardwareIndex#SubHardware

$dll(LHM.dll,2,0#0,0)
second parameter ignored but must be present (,0)

function 3
takes 2 parameters
Param1: sensor:

HardwareIndex#SensorIndex

$dll(LHM.dll,3,1#0,0)
or

HardwareIndex#SubHardwareIndex#SensorIndex

$dll(LHM.dll,3,0#0#0,0)
param2: maths for value

0 Direct value as is

or

operator#operand

operator: index one of

Index Operator effect
1 + addition
2 - subtraction
3 / division
4 * multiplication
operand: Value, value to add, subtract, divide or multiply by

or

Operator#Operand#DecimalPlaces

Operator and operand can be zero to just trim the decimal places of a direct number

Examples: get name, hardware index,

$dll(LHM.dll,1,0,0)
get value, hardware index 0# sub hardware 0# sensor 4, multiply# by 6# trim decimal to 2

$dll(LHM.dll,3,0#0#4,4#6#2)